RepAir Carbon's battery-style carbon capture technology validated

Sep 23 2026


A study with the University of Delaware published in Nature Energy shows that a carbon capture cell built on rechargeable battery chemistry can remove CO2 from ambient air using as little as half of the energy required by liquid-based systems.

Energy is the largest operating cost in direct air capture with most systems running at scale releasing captured CO2 using heat and consuming 1.5 to 2.5 MWh per tonne CO2. At European industrial heat and electricity prices that is more than €200 per tonne in energy alone, several times the current EU carbon price.

"Our customers ask which carbon capture technology can prove it will reach the cost target at scale. Operating cost is energy, and this paper settles that with peer-reviewed data. Capital cost is whether the equipment can be built on automated production lines that already exist. That is what we are building now." said Amir Shiner, CEO and co-founder of RepAir Carbon.

The cell described in the paper is the building block of RepAir's ElectraStack system - it captures and releases CO2 at high purity as it charges and discharges, using the same nickel hydroxide chemistry found in rechargeable batteries. The paper reports the same low energy consumption at three levels:

  • Independently, at the University of Delaware: a 25 cm² laboratory cell captured CO2 from ambient air (400 ppm) at an average energy cost of 1.15 MWh per tonne CO2.
  • Over time, at RepAir: a manufacturable single cell ran for more than 5,000 hours on ambient air and reached 0.46 MWh per tonne CO2 by the end of the test.
  • At larger scale, at RepAir: a nine-cell stack of 300 cm² cells averaged 0.83 MWh per tonne CO2 with a pressure drop below 300 Pa, meeting the requirements for efficient direct air capture at scale.

 

RepAir's is the only carbon capture technology based entirely on dry chemistry, with no solvents, liquids or heat at any stage. A dry cell has no solvent to degrade, replace or contain, so there is no bespoke chemical plant to build at each site. Capture equipment can instead be mass-manufactured and shipped as modules, as solar panels and battery cells are today.

The paper's supplementary information also reports results at 1% CO2, the concentration found in aluminium smelter flue gas. The cell is designed to operate from 0.04 to 5% CO2, where conventional capture struggles. That covers aluminium and copper smelting, both critical to the energy transition, and gas-fired power generation, now expanding to meet electricity demand from AI. RepAir's customers are the operators of these assets, together with carbon dioxide removal developers and e-fuel producers that need a reliable CO2 feedstock.

"Nickel hydroxide has been used in rechargeable batteries for many years, so it has a well established global supply chain and we know exactly how it behaves in an electrochemical cell," said Professor Yushan Yan, Henry B. du Pont Chair of Chemical and Biomolecular Engineering at the University of Delaware and co-founder of RepAir Carbon.

"What is new is arranging two identical electrodes of it around a membrane so that the cell captures CO2 on one side and releases it on the other, with the relatively reversible electrode reactions themselves consuming very little energy. The remaining losses are engineering problems with known solutions so they can be further reduced."

The paper also sets out a cost pathway from $566 per tonne for the current pilot generation to below $100 per tonne at volume, following learning rates observed in the battery industry. RepAir has since worked with several Tier-1 engineering, procurement and construction companies to confirm the roadmap.

RepAir has raised $30 million to date, and is supported by the European Innovation Council. Its technology has been selected for direct air capture projects on both sides of the Atlantic, and is now scaling up.

 

Read the paper
RepAir Carbon


Previous: Peak Cluster updates project infrastructure boundary after consultation

Next: Revcoo partners with Reazn to decarbonise the zinc industry






Issue 113 - Sept - Oct 2026

CCUS in Canada: Tax incentives in Alberta-Canada accord could spur EOR .. Agreement with Oil Sands Alliance advances Pathways .. Deep Sky delivers first climate credits INERATEC and Zeopore pioneer hydrocracking for CO2-neutral fuels .. OGCI report .....